3 Ways To Get Rid Of A Tree Stump Without Paying For A Stump Grinder

by admin |Lượt xem: 88

Rate this post

Have you cut down a tree and want to find a cost effective way of removing the stump? Or are you planning on removing a tree? Whichever it is, chopping down the tree is only a small portion of the work involved.

The real headache is removing what you can’t see. THE ROOTS AND STUMP!

Below are three methods you can use to rid your yard of those unsightly tree stumps.

BUT… before you read on, please like our FACEBOOK page and Follow us on PINTEREST so you never miss a post.

Table of Contents

Method 1: Remove The Stump By Hand.

View this post on Instagram

The GVSR 3 stages of stump removal, 1) Cut it, 2) Grind it, 3) Backfill! 3 jobs today took us from Blunsdon to Frampton-on-Severn and finishing in Stonehouse. #treestump #treestumps#treestumpremoval#treestumpsremoved #arblife#benburgess #treework #gardening#stumpgrinding#stumpgrindingservices #planting#treeplanting #treeservice#treeserviceanonymous#treeservices #nature #trees #tree#treecare #treetrimming#treecutting #treeremoval#treefelling #arborist #stihl #treebiz#arblife #chalford #stroud #gloucestershire #predatorpower

To remove a stump by hand you’re going to need A Chainsaw or limbing saw, Pick mattock, Axe, Shovel Crowbar or Heavy duty wrecking bar, hosepipe, pressure washer and a whole lot of time and patience.

The smaller the stump the less effort you’ll need to employ and it’ll certainly help If it’s an older or diseased tree but whatever way you look at it you’re going to get a good workout by choosing this method.

Instructions:

1. Use a chainsaw or limbing saw to remove any lower branches.

2. Remove the top portion of the trunk, leaving roughly 2ft of trunk exposed for leverage.

3. Use the shovel, pick mattock and digging tools to reveal as many of the roots around the stump as possible.

4. Use a hose or power washer to rinse dirt away to reveal more of the roots.

5. Cut and sever the major roots with an axe.

6. Rock the trunk back and forth to try and expose more roots that may be hidden and cut them with the axe.

Continue pushing and pulling the trunk until the tree trunk is entirely uprooted.

If Method one isn’t your thing then you could always do a Walter White and try the chemical route.

Method 2: Chemical Stump Removal

View this post on Instagram

#potassiumnitrate – source of to two major essential plant nutrients. Its commonly used as fertilizer for high-value crops that benefit from nitrate nutrition and a source of potassium free of chloride. ⠀ ⠀ ⠀ #cannabis #marijuana #420 #cannabiscommunity #weed #weedstagram

To remove a stump chemically, you will need the following:

A drill, A chainsaw, Potassium nitrate, an axe.

Instructions:

1. Cut off as much of the stump as possible with a chainsaw.

2. Drill holes around the outside edge of the stump at one inch intervals. Move inward by about 3 inches and drill another set of holes.

Ideally, these holes should be between 8-12 inches deep depending on the size of the stump.

3. Pour potassium nitrate into the holes. Fill the holes with water. Wait four to six weeks or until the stump becomes soft and spongy.

4. Use an axe to break up the stump.

Method 3: Rot The Stump

This method works by drawing out the moisture and accelerating the decomposition time of the tree stump.

Instructions:

1. Cut the tree stump as low as you can and then Drill holes roughly 8 to 10 inches deep.

2. Fill the holes full of Epsom salts (Magnesium Sulfate) and cover the surface and surrounding area with a layer as well

3. Pour water into each hole to moisten the salt but not so much that it becomes saturated.

4. Cover the area with a tarpaulin so that rain water doesn’t wash away the salt, Over time, this will draw the moisture out of the stump and surrounding dirt, thus accelerating the decomposition and preventing it from reshooting.

5. Once it’s rotted simply chip away and eventually fill the hole with soil as needed. This is a brilliant way to tackle your stump issues, however this is time consuming and it could take up to a year to complete the process.

The benefits however will be a fertile and rich soil that will promote plant growth after the job is done.

You may be wondering what the difference between method 2 and 3 are, well it’s down to how each chemical component effects the tree and surrounding area.

potassium nitrate, will help decomposition but will do little to kill a living stump and just make it more manageable when trying to cut it out. Epsom salt kills the stump while improving the surrounding soil by adding magnesium and sulphur. Science, isn’t it great?!

Conclusion:

If you’re thinking of removing the stump yourself you should weigh in the time, cost and effort that’s involved.

If you have to to buy or rent the tools to get the job done, it may just be easier and less stressful to let the professionals do it instead.

View this post on Instagram

Couple of before and after pictures from today. 7 suburbs 8 different jobs.Another big day coming up tomorrow. Follow us and click on some of our Instagram stories and highlights to see some video of our work. Call today for a great deal thanks everyone 👌😊 ☎️0415729419📞 #ipswich#flindersview #figtreepocket #chapelhill #bridgemandowns #eagleby #capalaba #stumpremovalbrisbane #stumpgrinder #stumpgrindingbrisbane #treeremoval #brisbaneturfing #brisbaneconcreter #brisbanepaving #brisbanetree #brisbanetreelopper #treestumpremoval #landscapingbrisbane #landscaping #brisbanelandscapers #yardcleanup #bandit #realstatebrisbane